The presence of auto wlan0 above causes the interface to be started at boot time. You should receive an IP if things are working correctly. Test the connection by running ifup wlan0 Assuming your wireless network runs in managed mode and you need only an ESSID (no WPA or WEP), add the the following to /etc/network/interfaces auto wlan0Īdjusting wlan0 as appropriate, and specifying your hostname and the ESSID of your wireless access point. This will be wlan0 if this is your only wireless device. You should see information about ndiswrapper initializing the device. Verify the module found the device by running tail /var/log/syslog Load the ndiswrapper module, which in turn loads the installed drivers from above, by running modprobe ndiswrapper If the dongle is not already plugged in do so now. Place the CD in the drive and install these with ndiswrapper: ndiswrapper -i /media/cdrom/netwg111.inf Included on the CDROM provided with the device are Windows drivers. To get a root terminal open a terminal and run sudo -s It is assumed you are logged in as root when performing this process. Strangely, there is also another WG111v2 that does not use the rtl8187 chipset and it will require ndiswrapper, so test for plug and play using iwconfig to determine if you need ndiswrapper. Note: Ubuntu 6.10 Edgy Eft supports the WG111v2 (rtl8187 chipset) with a native driver straight out of the box. WG111v3 can be used with the rtl8187 driver (or ndiswrapper if you must). A third version was released in 2008 (usb id 0846:4260). Though the author tested with the version 1 dongle it was reported that the version 2 dongle also works. This page describes the setup procedure for the Netgear WG111 (version 1) - a USB-based wireless dongle - in Ubuntu 5.04. If the device was already plugged in, make sure you reinsert it - the blue LED should now light up. Install the linux-firmware-nonfree package from the multiverse repository before plugging in the device: sudo apt-get install linux-firmware-nonfree This device requires proprietary firmware to function, as discussed in this thread. This article does not follow the style standards in the Wiki Guide.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |